- #Mpps v13.02 interface vag usb output software#
- #Mpps v13.02 interface vag usb output windows#
Switch off the ignition and close the program. #Mpps v13.02 interface vag usb output software#
Then follow software tips as follows: switch off keys→ wait 5 seconds→ switch on keys.
Locate your remapped file and then select “OK”. Back to MPPS software main menu and select “Write”. MPPS V13 read ECU data needs over one minute, after that save the file in an appropriate place with the file name of: YourName.bin. Select your car and engine from the menus provided. Once open, switch on your ignition to 2 clicks (until the engine check light is shown on your dash). Open the MPPS software through the shortcut on your desktop. Locate the diagnostic port and connect the tool. So remain still to avoid moving any wires or connections and close all other programs on your computer beforehand. It is very important not to disturb your computer while you are reading/writing the ECU. #Mpps v13.02 interface vag usb output windows#
For best results use windows XP and use a laptop with a fully charged battery.
The MPPS tool requires a stable laptop computer with a good battery. Hope it helps.īefore starting the work, please note that: Both MPPS V13 cable and MPPS V16 chip tuning interface can read and write ECU EDC15, EDC16, EDC17, MED9.x, Siemens PPD1/x, EDC15, ME7.xi, etc. This blog will show you how MPPS V13 and MPPS V16 read write ECU separately.
0 kommentar(er)
